Jet Mini Lathe 1014 Manual Tips,Clamp On Woodworking Vise Questions,Bosch Radial Arm Saw Model 4405 Netflix - Tips For You
Insert the spindle into the spindle pulley. Thread the handwheel onto the spindle. Center the spindle pulley and tighten set. Wrap the belt around the motor pulley. Tension the belt and tighten the motor plate. Loosen tailstock lock handle B, Fig.
Turn the tailstock handwheel A, Fig. Before installing the live center into the. Index Part. Description Size Qty. Headsto ck Whit e Headsto ck Spur Center Center Po int for Spur Center not shown Ball Bearing Wave Washer Set Screw J ML Drift Rod Spindle Pulle y Door White Spi ndle Pulley Door Roll Pin Round Head Sc rew He x Jet Mini Lathe 1014 Manual Zoom Nut Hex Socket C ap Screw Lock Washer Spindle Pulley New White Bed Moto r Pulley Door White Mo tor Pulley Door Lock Knob Flat Washer Hex Cap Screw Mo tor Pulley Lo ck Nut He x Cap Bolt Moto r Bracket Handle Prot ector Wh ite Handle Pr otector C apacitor not shown Capacitor Cover not shown Moto r Fan Cover not shown Tool Rest Body White Tool Res t Body T ool Rest Eccentric Rod Bush ing Live Center Head Center Po int for Live Center not shown Ba ll Bearing Live Center Shaft Live Center Assembly not shown Tailstock Spindle White Tails tock Safety Switch Switch Bracket Round Head Machine Screw Switch Cover Stain Relief Bushing Co rd Clamp Stored in the hole in the base below the headstock.
NOTE: Always catch the spur center with your other hand as it falls, to prevent damage to the tip. Tool Rest Fig. Page Variable Speed Control Variable Speed Control The variable speed control box contains the electrical connections to the motor, and has three external controls. Never start a workpiece at maximum speed. Power Switch A, Fig. Page Belt Replacement 3. Loosen the motor plate lock handle A, Fig. Lift up on the motor plate handle B, Fig.
Move the belt B, Fig. Loosen tailstock lock handle B, Fig. Turn the tailstock handwheel A, Fig. NOTE: Catch the live center in your other hand as it falls, to prevent damage to the tip. White Headstock Spur Center Center Point for Spur Center not shown Live Center Assembly not shown Tailstock Spindle Lead screw Drift Rod Figure 7 — Page Belt Replacement 4.
Move the belt E, Figure 9 to the desired pulley groove according to the speed chart found on the inside of the headstock access door. Be sure the belt is aligned with spindle pulley and motor pulley. Tension the belt by pushing down on the motor plate handle D, Figure 11 and re- tighten lock handle C, Figure 11 Belt Replacement Page Index Pin Lathe centers. There are 24 index positions on the lathe. To use the index pin Figure 13 , screw it farther into the headstock until it engages a hole in the spindle pulley.
Part No. Description Size Spur Center Center Point for Spur Center Page 15 Eccentric Locking Rod Lock Handle Assembly, Tailstock White Tailstock Hand Wheel Page 18
Woodwork Bench Risk Assessment Review How To Build A Steam Box For Wood Ultra |
joni
12.05.2021 at 10:10:47
Gulesci
12.05.2021 at 22:16:32