%!$ Easy Diy Woodworking Bench Plans For You #!@

10 rows · Sanding belt size: xmm: No load speed sanding disc: /min: No load speed sanding. curved workpiece on the top wheel of belt. AVOID kickback by sanding in accordance with directional arrows. Sand on downward side of disc. Sanding on the upward side could cause the workpiece to fly up and cause an injury. ALWAYS maintain a maximum clearance of 1/16" or less between the table and the sanding belt or disc. Oct 06,  · MAKE SURE the sanding belt runs in the proper di-rection. See directional arrow on back side of belt. MAKE SUREthe sanding belt or disc is not torn or loose. SUPPORT workpiece firmly with the miter gage, backstop or work table when sanding with the belt. NOTE: The only exception is curved work performed on the top wheel of belt.
Oct 06,  · MAKE SURE the sanding belt runs in the proper di-rection. See directional arrow on back side of belt. MAKE SUREthe sanding belt or disc is not torn or loose. SUPPORT workpiece firmly with the miter gage, backstop or work table when sanding with the belt. NOTE: The only exception is curved work performed on the top wheel of belt. Remove the belt sander fence (8). • Put the belt in its vertical position. • Loosen the sanding rest fixing bolt shown in the illust-ration above. • Install the sanding rest (12) with the flat on the fixing leg facing the bolt. • Adjust the rest so that there is approx. 2mm gap between the rest and the belt. • Tighten the bolt with the 14mm open- end spanner. FIXING THE BELT SANDER. This stationary belt and disc sander from FERM has a motor capacity of W. The versatile sander has a mm disc for sanding small workpieces and details and is flexible in use thanks to the adjustable sanding belt position. With this sander you work comfortably thanks to the adjustable and multifunctional work www.- s:

Best-router-for-router-table-with-lift-notification Carpentry-hardware-shop