%!$ Easy Diy Woodworking Bench Plans For You #!@

If you sand on the upward motion side, the disc will lift the piece off the table and cause a kickback. Once inside the nelt zone, adsessment slightest mistake can result in an injury. Welcome to Shopsmith. When using the quill feed to advance the disc, back up the stock with the rip fence. Safety Rules for the Belt and disc sander risk assessment analysis Sander. Never reach under the table while the sanding disc is running to tighten the locks or make adjustments. Don't turn on the power with the stock laying on the worktable or already in contact with the disc.

Access to internal area of machine. Fixed guarding encloses all transmission and associated moving parts LOTO protocol implemented and maintained. Work piece thrown from the machine. Work table or rest is used to guide work piece during sanding Safety glasses are worn by the operator. Variation in material size, shape and weight. Store raw materials at appropriate height to avoid the need for bending or twisting Use a second person or trolley to guide a long or large piece from the machine.

Obstructed or cluttered work area around the machine Slippery and uneven floor surface. Maintain a clear work space in and around the machine Provide non-slip floor surfaces that give a firm foothold. Provide and maintain local exhaust ventilation Wear protective personal equipment PPE such as face masks Regularly vacuum dust and sawdust Note: DO NOT use compressed air to remove dust from skin or clothing.

Book An Appointment Today! Schedule an Appointment Online Click Now. Safety Rules for the Disc Sander. Always wear proper eye and ear protection, and a dust mask. If you're doing a large amount of sanding, you should wear a respirator. Don't turn on the power with the stock laying on the worktable or already in contact with the disc.

Never reach over the disc or behind it while it's running. Always sand on the downward motion side of the disc Figure The rotation helps to hold the workpiece against the table.

If you sand on the upward motion side, the disc will lift the piece off the table and cause a kickback. The one exception is when you use the quill to advance the disc. The rotation of the disc may lift wider boards off the table. When you use the quill feed to advance the disc, attach the quill feed lever to the side of the power plant where you can reach it most easily.

Always use the worktable; add the extension table if necessary. Never sand without a table supporting the stock. When using the quill feed to advance the disc, back up the stock with the rip fence. If the stock is too long to backstop, clamp the stock to the worktable or extension table. Close [X] Welcome to Shopsmith. Address Line 2. Western Sahara Yemen Zambia Zimbabwe. They will Call you Back.

If your equipment is under Warranty , call our Customer Care Line at at no charge to you.

Rockler-lathe-video Pull-out-drawer-slides-quote Ogee-router-bit-sizes-github Under-workbench-drawer-kit-05