Mastercraft Belt And Disc Sander Manual Online,Single Stage Dust Collector Modification Java,Radial Arm Saw Ripping Jig Zone - And More
Turn the power off and remove the plug from the outlet before changing the accessories. Removal: 1. Slide tension lever to the right to release the belt tension. Slide the used sanding belt off of the rotational mechanism.
Installation: 1. Page 12 To properly track the sanding belt: 1. Plug in the sander. Turn power switch ON, then immediately OFF, noting whether the belt tends to slide off its track, and to which side front or back of the sander. If the sanding disc did not tend to either side, it is tracking properly. Page 13 Sanding operations are inherently dusty. Depending on operator needs and the workpiece, the work-support can be used with either the horizontal or vertical position.
Page 15 Surface Sanding on the Sanding Belt When sanding flat, broad surfaces on the belt sander, hold the workpiece firmly but lightly onto the surface of the belt and against the work support work rest , keeping fingers away from the sanding belt. Page 16 Sanding Disc Station - Sanding Outside Curves Always sand outside curves using the sanding disc and moving the workpiece from the left side of centre, as shown.
Keep the curve pressed firmly against the sanding disc, moving the work evenly from the left side of the sanding disc. DO NOT attempt to repair or maintain the electrical components of the motor. Take the sander to a qualified service technician for this type of maintenance.
Ensure sanding rub off belt or discs. Page 19 Motor overheats. Motor overloaded. Reduce load on motor 2. Utilize an extension cord of appropriate gauge and length or plug tool directly into outlet. Motor stalls resulting in 1. Page 20 Parts Schematic Print page 1 Print document 22 pages. Cancel Delete.
Sign In OR. Don't have an account? Table of Contents. Previous Page. Next Page. Related Manuals for Craftsman Summary of Contents for Craftsman DONOToperate t hetoo! G Attach pulley cover 1 using the 40mm long pan head Remove and clean any adhesive or material left on the screw 2 and 12mm pan head screw 3 , as shown.
J The worktable can be used with either the sanding disc or the sanding belt. It should be used to support workpieces in all Mastercraft Belt And Disc Sander Parts Kit sanding operations except inside curve applications. Insert the table support rod 1 into the sander base To avoid injury, always keep the plug disconnected from the power source and the switch Mastercraft Belt And Disc Sander Manual 90 turned OFF until the hole as shown.
S, T, U Fig. U Insert the handle of the wrench into the metal clip located on the sander as shown. To avoid injury, always keep the plug disconnected from To avoid injury, turn switch OFF and disconnect the plug Fig, Q the power source and switch turned OFF until the sander
Build Your Own Fruit Cage Frame Frame Cnc Drill Bits For Wood Detection Crown Moulding Router Bit Set Kit Thick Veneer Vs Laminate Zipper |
454
29.10.2020 at 15:44:12
RESUL_SAHVAR
29.10.2020 at 10:54:10
LADY
29.10.2020 at 13:23:51