%!$ Easy Diy Woodworking Bench Plans For You #!@

craftsman-jointer-planer-install Page 2 general safety craftsman jointer planer install. Cancel Delete. Page 7 Turning the handwheel counterclockwise will lower the Release the handle and continue loosening. Page 22 MOTOR ladas de modo que los dos bordes que pasan por los bloques cepillado encajen perfectamente en una uni6n sin costura. Page 20 Figura 5. Page 15 a, Insert a pencit in space at craftsman jointer planer install of cutterhead hold cutterguard open, b, Place a planwr large square outfeed table, First along one side than other, Insall infeed table until touches d, Sight between table and straightedge high condition It is easier to adjust the infeed table while

Protect hands from pos- sible injury. Removing the key from rocker switch will lock Is Connected the unit and prevent unauthorized use. Page 7 Turning the handwheel counterclockwise will lower the Release the handle and continue loosening. Turning the handwheel clockwise will raise angle.

Use a bevel scale or protractor to measure tilt the infeed table causing less wood to be removed from angle. Using bad lum- alignment. Feed the board at a continuous even rate of speed. Refer to Figure Secure with screws.

Refer to Figures 23 and Defective switch 1. Have switch replaced 2. Defective motor 2. Low line voltage 3. Page 14 Model Page 16 Model Craftsman Table Top Jointer Planer La bolsa de artfculos de ferreteria incluye: AsegtJrese de que el interruptor est,. Page 20 Figura 5. Page 22 MOTOR ladas de modo que los dos bordes que pasan por los bloques cepillado encajen perfectamente en una uni6n sin costura. Consulte la Figura Haga avanzar la tabla a una velocidad uniforme y continua. Asegure con tornillos. Interruptor defectuoso 1.

Solicite el reemplazo del interruptor 2. Motor defectuoso 2. Page 32 Your Home For repair-in your home-of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it!

Page 2 general safety 1. Learn limitations as well as the specific peculiar to this tool. Page 5: Motor Specifications And Electical Requirements motor specifications This machine is designed to use a Do not use any motor that runs faster It is wired operation on volts, nating current.

The fence should be positioned to the extreme right toward pulley but not beyond the end of the blades. Page Fence Tilt Scale b. Tilt to desired angle knobs. Page Infeed Table to know your e. It must always be in place and function- ing properly.

Page 15 a, Insert a pencit in space at end of cutterhead hold cutterguard open, b, Place a straightedge large square outfeed table, First along one side than other, Raise infeed table until touches d, Sight between table and straightedge high condition It is easier to adjust the infeed table while Page 17 b, To turn machine insert finger lever and pull end of switch out.

To turn machine OFF PUSH lever in. Never leave machine unattended until to a complete stop. To lock switch in OFF position.. Do not plane, joint or bevel wood shorter Material this Remove belt guard, 2. Position fence right. NOTE: Sears has a knife setting gauge for this purpose.

Remove cotter pin from pivot pin in cutter remove guard located underneath Spring must appear as in sketch from feed table, will perform properly upside down. Page 24 5. Replace guard and cotter pin.

Pressure Treated Lumber Products Brands Rate Plans To Build Router Table Grid Johnson Hardware Open Close Arm Mac