Tool For Drilling Pocket Holes Library,Vinyl Sanding Sealer Zero,Sam Maloof Oil Treatment,Veneer Supplies Melbourne Pdf - Step 2
tool-for-drilling-pocket-holes-library
1 Remove the Drill Guide Block from the drill-guide socket of your Kreg® K3, K4, or K5 pocket-hole jig. 2 Slide the Plug Cutter guide block into the drill-guide socket, seating it all the way at the bottom. Secure the guide with the locking pin. 3 Slide the stop collar onto the . Pocket-Hole Placement 6 In addition to the proper Kreg Jig® settings, spacing pocket holes evenly across the workpiece is an important part of getting a strong joint. The Kreg Jig® features a three-hole drill guide that allows you to do this in a variety of workpiece widths without the need to reposition the workpiece after drilling each hole. Jul 05, · Step 1. Drill the pocket hole. A special step drill bit not only drills the pocket hole, but it also drills the guide hole for the screw in one quick motion (for more on step bits, see our Drill Bits Buying Guide). Simply clamp the pocket hole jig securely to your wood, and drill the hole.
Pocket-Hole Placement 6 In addition to the proper Kreg Jig® settings, spacing pocket holes evenly across the workpiece is an important part of getting a strong joint. The Kreg Jig® features a three-hole drill guide that allows you to do this in a variety of workpiece widths without the need to reposition the workpiece after drilling each hole. The K4 has 3 drill-bit guides, making it possible to drill multiple pocket holes without moving the board. When clamped, you simply drill the pocket hole using these bit guides, with the special stepped drill bit that comes with the jig. Then unclamp, slide the board down, and repeat. Or remove the board, place the new board, clamp and repeat. At a minimum, a pocket hole jig kit should provide the drill guide itself, a suitable drill bit (usually 3/8 inch), a depth collar that fits over the drill, and a hex key to tighten it. Pocket hole jigs have minimum and maximum capacities in terms of the thickness of board they can successfully join. Normally, this is from 1/2 to 1 1/2 inches.
Cleaning Old Woodworking Tools Marking Knife Holder Meaning 14 Inch Drawer Slides Home Depot Sim |
spaider_man
20.12.2020 at 16:42:42
sakira
20.12.2020 at 15:53:46
BRIQADIR
20.12.2020 at 22:19:19
narin_yagish
20.12.2020 at 12:28:47