Diy Wood Connect 4,Wood Projects Christmas Gifts 80,Wood Projects Designers Technology - Easy Way
I painted the inside of the game board before putting it together. You need this spacing to be right. If its off, while playing the game the disc will lean to one side or the other. The disc will not line up with the holes on the game board and look funny. The legs are mad up of two piece each.
They are hinged together for easier storage and to maximize the plywood. The bottom half was cut out on the band saw. Then cleaned up at the sander. The top and bottom are joined together with hinges. I mortised out for the hinges, but this is not required. During the test fit. I found that I had to sand the sides of the game board to get them to fit right.
This was because the center dividers on the end was not cut straight and I had some high spots to correct. The game board turn out great the chips are lined up perfect and no gap. The release is held on by two hinges and this latch. To release the chips undo the latch and they fall right out. Assembly is easy. Open the legs place one on each side and push down. I assume you didn't use the cutout circles for the chips?
Reply 4 years ago. Introduction: Yard Connect Four. By mfwoodshop www. More by the author:. About: Thanks for visiting my page. Just a little about me. I love working with wood products and really enjoy coming up with new ways to create something. I have been woodworking… More About mfwoodshop ». Rip the plywood to width and length.
Layout all the measurement for the both panels. Before any paint went on. Next I copied that piece with a flush cut bit.
I placed the hinges, marked out for the hing. Then use a router to clear out the area. Attachments Connect Four. Participated in the Wood Contest View Contest.
Participated in the Outside Contest View Contest. Adding paint, filling in holes with wood filler. Welcome to the line of people addressing this error in the plans. I had hoped the author would have revised it. Also commented on — do not fill the holes — leave them alone. The plans erred in spacing the same distance as the thickness. A corded drill is a far better choice. This dimension would cause the stack of game pieces to not be centered in the holes.
Just my two cewwnyts worth. Thank you for these instructions. I have been looking for directions like this for a while. I did make some modifications.
The diagrams were very helpful. Thanks again. I'm Jenn. Thanks for stopping by Build Basic. Click on the photo to learn more. Using the cut list above, cut the plywood pieces to size. Place the plywood pieces on support blocks. Clamp the plywood and support blocks firmly to the work surface. Because hole saws can wander a bit until the drill bit bites into the wood, drill pilot holes at each crosshair.
Choose a drill bit with a sharp point, like a brad point drill bit. To see my tips on how to use this tool, see my tutorial HERE. Place the panels back-to-back.
Position the boards between the plywood panels flush with their side edges. Clamp the parts together. See the Building Plans above for reference. Nail through the plywood panels and into the dowels from both sides to hold them in place. Using a pocket hole jig, drill pocket holes in one end of each horizontal 1 x 3.
Apply wood glue to the end of the board. Clamp the board against the edge of the inch Stand, flush with its bottom edge. Attach a second board on the opposite side of the Stand. Repeat to create the second leg.
Hold a 1 x 3 angled from the tip of the horizontal piece to a height of 11 inches on the Stand. Mark the angle at each end, and then miter the pieces to size. See the Building Plans for reference. Apply wood glue to the sides of the assembled plywood panels.
Pumpkin Carving Kit Tool Names Template Waterlox Sealer Vs Finish |
murad
14.08.2021 at 18:20:17
ASad
14.08.2021 at 22:25:34