Clarke Belt And Disc Sander Spares 91,Cheap Digital Tape Measure 65,Shop Vac Dust Filter Home Depot - Tips For You
Installing Sanding Disc And Guard 1. Locate sanding disc and peel backing from disc. Locate table support and 3 M6 hex head screws, flat washers and lockwashers among loose parts. Position table support against table, aligning holes as shown. Fasten table support to table as shown. Locate washer 6. Remove table assembly by removing table lock knob and washer. NOTE: Belt bed may be raised to vertical position by loosening hex socket screw and raising bed.
Page 12 3. Slide tension lever to the left to apply belt tension. Tighten hex socket screw when bed is in desired position. Plug in the power cord. Work Support. Supports the workpiece on the sanding belt. Hex Socket Head Screw. Loosening screw allows belt bed to be raised to the vertical position.
This feature is intended to help prevent unauthorised and possibly hazardous use by children and others. NOTE: Key is made of yellow plastic, located in loose parts bag. Loosen the table lock knob and tilt the work-table to desired angle as shown. Retighten table lock knob. WARNING: To avoid trapping the work or fingers between the table and sanding surface, the table should be repositioned on the table support to retain a maximum When checking clearance between the belt and work support, press the belt flat against the bed beneath it.
Hold the workpiece firmly with both hands, keeping fingers away from the sanding belt. The unit must be reassembled exactly to factory specifications. Page Troubleshooting 4. Slightly tighten 3 screws. Adjust tension of belt by putting blade screwdriver in adjusting hole. Inspect the sander for worn or broken parts regularly. Replace any worn or broken parts before using the sander. Don't operate your sander in explosive atmospheres such as in the presence of flammable liquids, gases or dust.
The sander can produce sparks that may ignite dust or fumes. Keep children and bystanders clear of the work area when operating the sander. Distractions can cause you to lose control of the sander. Air Compressor. Bottom-Mount Refrigerator. Downdraft Ventilation System. GE Downdraft ventilation system Parts. Dvd Player. LG Dvd player Parts. Front-Engine Lawn Tractor. Craftsman front-engine lawn tractor parts. Gas Snowblower. Murray X6A gas snowblower parts. Grass Catcher Attachment. Husqvarna Grass catcher attachment Parts.
Refrigerator Common Questions. Schwinn Treadmill Parts.
Tongue And Groove Bit Set Pdf Woodwork Workshop Belfast 50 |
BubsY
19.10.2020 at 13:28:59
Azeri_girl
19.10.2020 at 14:39:50
Gokan_ozen
19.10.2020 at 14:16:51
TeNHa_H
19.10.2020 at 19:43:23