Popular Woodworking Bookcase Plans Review,Aldi Belt And Disc Sander Review,Best Tools To Split Wood Jacket,Cutting Wet Wood Miter Saw Review - How to DIY
Because of this, the location of the shelves actually falls at an angle on the sides. With the sides clamped together and mounted in my vise, shaping the sides simply took some sanding and planing. With some of the cuts, the majority of the side will be supported by the miter gauge, and you can use your rip fence to guide your cut. When the larger section of the side will be between the blade and rip fence, this is an unsafe cut.
The board can twist and bind against the blade and cause a kickback. Move the rip fence out of the way, mark the sides and make the next cuts with only the miter gauge fence. With the dados complete, swap the dado with a crosscut blade, and bevel the bottom edge of each side at that angle.
A close look at the wedged through-tenons shows the recess behind the side that allows the wedge to pull the sides tight. The next step is the through-mortises. You could also set up a mortiser to do the job, but I got a little smarter and came up with a router template. It takes some rearranging of the guide for the different cuts, but the results work rather well. Careful layout lines are critical here. The rest is fairly simple. Mark that size on the template and use a drill and jigsaw to make a square hole.
Clamp the template in place over the mortise locations and cut your through-mortises using two or three depth settings. I used a jigsaw and chisel to square up the corners. I used my band saw for most of this work, but used a jigsaw to cut the radii under the top shelf and the arch at the bottom.
Cut a little wide of your layout lines, then clamp the sides together, aligning the sides by the shelf grooves on the inside surface. Plane and sand the sides to matching shapes. Start by checking the fit of your shelves in the dados in the sides. Mine were a hair thick, so I was able to run them down on the planer to make an almost-perfect fit. Check the width of the bottom shelf against the width of the sides at the shelf location, Popular Woodworking Bookcase Plans 09 now that the sides are shaped.
Rip the shelf to size. Next, fit the shelf into the dado and, from the outside, mark the tenon location through the mortise on the end of the shelf. The width of the tenons is the critical cut. With the tenons cut for the bottom shelf, fit the shelf and sides together. You want a snug fit, but not too loose and not too tight. A chisel, file or rasp and some sanding should do the job. Take your time and get it right. With the bottom shelf fit, check the dimensions on the top shelf, mark the tenons and repeat the fitting process.
When that task is complete, fit the two center shelves and slide them into position. Bookcase plans like ours will open your eyes to a world of larger possibilities in home improvement and furniture design. Build your own bookcase this weekend, and start the journey!
Biscuits not the kind you eat. Our editors simplify those options by focusing on biscuit joinery — a fast and easy way to line up all the boards in your project and get on with the gluing and screwing. Built-in bookcase plans are different from stand-alone bookcase plans. You may know how to build a bookcase that sits next to a wall, but do you know how to integrate your bookcase with the wall?
We teach you 3 secrets for how to build built-in bookcases: French cleats, fitting strips and scribe stiles. Better and best. There are plenty of good bookcase plans out there — and most of them are free.
Bibliophilia — love of books!
Treated Lumber Projects Quizlet Wood Lathe Scraper Tool 800 Chisel Sharpening Jig Toolstation |
TeNHa_H
01.05.2021 at 22:57:31
BOMBAOQLAN
01.05.2021 at 10:24:54
SEKS_MONYAK
01.05.2021 at 22:54:49