%!$ Easy Diy Woodworking Bench Plans For You #!@

I couldn't sleep, so I made knives. For Burning Man gifts. Ingredients: 1. A dull hacksaw or bandsaw blade 2. Electrical tape or really wide heatshrink trom Tools: 1. A piece of paper 2. If you are not familiar with grinders or otherwise do not know proper grinder safety, please do not attempt this and ask someone for assistance. Draw with a pen an outline of the hacksaw blade on the piece of paper. We used a blade so dull that it bldae described as "polished".

Choose a point shape and any details you may want. We used square cut for these illustrations. Use your hand to figure out where would be comfortable to hold from and where your thumb will go. Using the paper template, mark on hackaw blade where you plan to cut it, and the thumb notch etc haclsaw plan to grind out.

Score the band with a file at the place s marking knife from hacksaw blade 70 need straight cuts. Then put the blade in a vise to hold it tightly, and use pliers to snap the blade off. We spent about 45 minutes setting up the grinder, but hopefully your grinder is ready to go.

Karking any sharpness the blade may still have. Sharpen both sides of the other edge at an angle of 15 degrees. Keep your fingers marking knife from hacksaw blade 70 the side opposite the grinder while you are doing so. This should only take a few minutes once you set up the grinder. Grind out the thumb indentation. Again, keep your fingers on the side opposite the grinder while you are doing so.

Use electrical tape and wrap it tightly around the dull end of the knife to make the handle. Or, you can mraking some large gacksaw shrink tubing and use that. This instructable was made at Ace Monster Toysan awesome hackerspace in Oakland, California -- if you're in the area please stop by sometime!

Reply 6 years ago mafking Introduction. I suggest dipping the blade in water very often when grinding. Keeping the blade cool helps to preserve the temper and keep the blade as sharp as possible. I couldn't sleep, so I made knives in my case : i couldnt get an airsoft gun so i made crossbows.

The steel from these blades maroing very brittle and extreme caution should be taken while using them to markjng cutting your own hand if it breaks because it will break. By davr. More by the author:. About: Member of an awesome hackerspace, Ace Monster Toys. More About davr. Did you make marking knife from hacksaw blade 70 project? Share it with us!

I Marking knife from hacksaw blade 70 It! Incredible Wooden Spirals by rschoenm in Woodworking. Reply Upvote. EmmanuelHesus 5 years ago on Step 7. SmellierCow 8 years ago on Introduction. It wouldn't, if you use a bimetal high-speed blade. Bimetals are little bit harder. Bobblehead Einstein 8 years ago on Introduction.